6x Vintage Outer Cable Stops for Bicycle, Moped & Lawnmower (6 Pieces)

Six steel outer cable stops. This set addresses a concrete inventory requirement in the workshop: the hard stop that gives a cable housing a firm, defined seating point on a frame, lever or engine casing.

Why these stops matter for cable routing

The outer cable stop is a small but decisive part of a control line. It prevents the housing from sliding through the frame stop under load. That keeps the inner cable travel short and direct. This set of six covers several positions on one machine, or several machines in the workshop stock.

• Material: Acier
• Quantity: 6 pieces
• Use: Bicycle, moped, lawnmower

The existing photos are an integral source of information for any buyer. They document the actual shape, surface condition and size of each piece. A major defect, if present, would be stated in the listing text. Minor cosmetic marks or storage-related wear, such as micro-scratches, may be present even when not individually photographed.

For a cable-driven setup on a classic machine, a clean stop at the end of the housing is as useful as the cable itself. These six steel stops serve exactly that function, with no surplus material in the lot.

Where a plastic guide is preferred for a double cable run, the vintage plastic double cable guide remains an alternative. A complete rear derailleur circuit can also require a different clamping point, such as the NOS Simplex gear cable guide clamp.