Fitting a period mudguard to a classic frame often comes down to the small hardware: the stay bracket, its bolt, its nut. This lot supplies those parts six times over, in steel, with a 5.3 mm fitment stamped into the reference name. The parts come from France.
Nothing here is oxidised — — so the finish on each bracket, bolt and nut is intact. That matters when the rest of the build is being brought back to a consistent standard: a rusty fastener stands out against a clean stay.
What the six-piece set covers
Six brackets, six bolts, six nuts. Enough for a full bicycle where both front and rear stays need brackets at each end, or for a workshop drawer that gets raided every time a mudguard goes on. The 5.3 mm figure is the fitment dimension named in the product reference, so check it against your existing stay before ordering.
For anyone assembling a complete period-correct machine, it helps to look at the wider selection of lighting, mudguard and rack components held alongside these fastenings, as well as a set of steel handlebar 24.8–380 mm if the cockpit is being renewed at the same time.
, no oxidation. Minor cosmetic marks or traces of long storage may be present; anything significant is noted in the listing. The photographs supplied with this listing form part of the description, so the exact appearance of the brackets, bolts and nuts can be checked there.
Key Specifications
- Country of origin: FRANCE
- Oxidation: No
- Material: Steel
- Manufacturer part number: 0000
FAQ
What exactly is included in this set?
Six mudguard stay brackets, each supplied with a bolt and a nut. That gives six complete fastening units in steel.
What does the 5.3 mm measurement refer to?
It is the fitment dimension named in the product reference for these mudguard stay brackets. Check it against your existing stay before ordering.
Is there any rust on these parts?
No. The set shows no oxidation. Minor cosmetic marks or traces of long storage may be present, and the photos form part of the description.
Where were these brackets made?
France. The set is steel throughout, with manufacturer part number 0000.
Can I use these on a single bicycle?
Yes — six brackets cover front and rear stays where a bracket is needed at each end, with spares left over for future fits.
