Banner
This listing is for a used FRANCO racing handlebar. It is defined by a 390 mm overall width and a 22 mm clamp diameter. These two numbers are the starting point for anyone matching a bar to an older road frame and stem. The unit shows the patina of a part that has been mounted and ridden. What you see in the photographs is what is included — the visual record of the bar’s surface, curvature and ends is the authoritative condition note for this piece.
The 390 mm span sits at the narrower end of the period range. That matters on a small or medium classic frame where lever reach and drop shape had to work together. The 22 mm clamp is a specific interface size. A mismatch here will prevent safe installation.
This FRANCO bar fits the logic of an Eroica-eligible machine or a period-correct French build. The surface may carry light marks, small scratches or dulling consistent with age. No major structural fault is reported for this bar. For a complete front end, pair it with a matching stem from the 3ttt 400-21.8 mm vintage handlebar or check other 410 mm racing bends from the same shelf. If the whole cockpit is being rebuilt, the FRANCO R213 shares the same 390-22 geometry and may be useful for comparison.
The bar measures 390 mm in overall width and has a 22 mm clamp diameter. Always check that your stem matches the 22 mm clamp size.
Yes, the 390 mm width and 22 mm clamp are consistent with period-correct road bikes. Verify the geometry of your frame and stem before assembly.
It is a used part. The photos show the actual surface condition, including any light marks or wear from service and storage. No major structural fault is indicated.
Data sheet
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
Review sent
Your review cannot be sent
Brand: Philippe
Brand: Philippe
Brand: BELLERI
Brand: 3TTT
check_circle
check_circle
