Handlebar racing 340 - 24.5 mm vintage bike Eroica R216

The 340 mm width on this racing handlebar marks it as a piece intended for a more compact cockpit, typical of smaller vintage frames or riders who favour a narrower position. The 24.5 mm clamp diameter is the other critical figure; it determines the stem you will need to secure it. Both measurements come straight from the product designation, not from guesswork.

This is a used component. The images in the listing are part of the description and show exactly what you are getting. Minor cosmetic marks from storage or previous use may be present, and the photographs document the current state far better than a summary ever could.

A Classic Bend for Period Builds

Vintage racing handlebars of this kind suit a range of older road bicycles. The proportions are modest, the profile is traditional, and the patina will match a frame that has already seen some decades. If your project is a restoration that should look coherent rather than brand-new, this is the sort of hardware that keeps the whole build believable.

For a matching cockpit setup, take a look at the handlebar grips or consider another bend from the same family, like the 390 mm racing handlebar, if a wider stance would fit your build better.

What to Check Before Mounting

• Stem clamp diameter: 24.5 mm
• Total width: 340 mm
• Condition: used, documented in photos

The clamping zone is the one measurement you cannot adjust by shimming without adding an extra variable. Verify your stem accepts a 24.5 mm bar before planning the rest of the assembly.